Return to site

Test System Circuit Boards

· test system,test,test system design

Early on in my career, I saw a test system with multiple screw terminals and wires going all over the place. And then (inevitably), there'd be a problem with the system. The problem would be fixed once a loose wire was identified and then put back in place, but someone had to go through all of these wires to figure it out.

But if everything is connected to a circuit board, you will greatly reduce problems with wiring. In addition, recreating your test system or even just disconnecting a card for calibration is much easier. On this board, you can also add any additional components: load impedance, extra transistors/relays, signal conditioning, etc.

So before you start soldering things for a custom cable or wire harness for your test system, at least consider making a circuit board for the long term.

All Posts

Almost done…

We just sent you an email. Please click the link in the email to confirm your subscription!

OKSubscriptions powered by Strikingly